Fluke 9100S Handheld Dry-Well

The Fluke 9100S Mid-Range Field Calibrator may be used as a portable instrument or bench top temperature calibrator for calibrating thermocouple and RTD temperature probes. This instrument is small enough to use in the field, and accurate enough to use in the lab.

Temperature display and setability resolution is 0.1 degrees. The temperature is accurately controlled by Fluke’s digital controller. The controller uses a precision platinum RTD as a sensor and controls the well temperature with a triac driven heater.

The LED front panel continuously shows the current well temperature. The temperature may be set, using the control buttons, to any desired temperature within the instrument’s range. Multiple fault protection devices insure user and instrument safety and protection. This dry-well calibrator was designed for portability, low cost, and ease of operation.

Through proper use, the instrument will provide continuous accurate calibration of temperature sensors and devices. The user should be familiar with the safety guidelines and operating procedures of the calibrator as described in the instruction manual.

The instrument features:

• Rapid heating and cooling
• Prop stand
• RS-232 interface capability

Built in programmable features include:

• Temperature scan rate control
• Eight set-point memory
• Adjustable readout in °C or °F

Range: 35°C to 375°C (95°F to 707°F)

Accuracy: ±0.25°C at 50°C±0.25°C at 100°C ±0.5°C at 375°C

Stability: ±0.07°C at 50°C±0.1°C at 100°C ±0.3°C at 375°C

Resolution: 0.1°C or °F

Well-to-Well Uniformity: ±0.2°C with sensors of similar size at equal depths within wells

Heating Times: 35 to 375°C: 9.5 minutes

Stabilization: 5 minutes

Cooling Times: 375 to 100°C: 14 minutes

Fixed Block Options: See Section , Constant Temperature Block Assembly, on page and figure on page

Weight: 1 kg